Choosing Pilot Hole Size For Beginners 04

Diy floating pallet bed frame with this recipe How to cut a dovetail joint by hand

If cut for a sink is necessary, it needs to be put to a table-top and to make a pencil a marking. On the edge of the line of a marking such opening that the electrofret saw file well entered it is bored through. After cutting of a nest the sink is inserted into it and fixed by special fastening (it goes in a set).

The drawing of an added locker under a sink is necessary if you were going to do a design by the hands. By the way, it is not so already difficult and if you did any other elements for kitchen by own efforts, and with a locker will cope.

There is one more option, the same sizes – 900 by 900 mm, but at a design two doors. It is possible to make so that two facades will open at the same time, or separately.

According to the drawing the case and assembly is much easier to collect will be clear where everything accurately goes according to the plan. The ready standard drawing can be taken on the Internet.

Angular modules or their parts for kitchen can be made most.

Before projecting the drawing, decide on the following:

As for the novelties simplifying life it is necessary to remember vykatny elements. Mesh vykatny baskets really are in considerable demand, you only pulled for the handle, and the basket softly to itself left a curbstone. Usually there means of household chemicals, a brush, rags, etc. are stored.

On a locker door under a sink it is possible to attach and vykatny the garbage container. By the way, it can be also two baskets, with a cover or without.

And if it is difficultly to argue on external qualities of a curbstone, all of you equally choose the locker suitable to a set, it is possible to talk about the internal device.

The angular option is the best decision for those who wants to save meters. And it is not always the compelled compromise as the design of such sink can be very interesting, and convenience of use at all not below, than at a direct locker.