Note. In this project lobbies and a back vice of Lee Valley are used. They differ in high quality of production, smoothness of work and are delivered with the detailed instruction on installation.
Shift the centers of openings 1,5 mm closer to a crest coat hanger that, driving in with shkant, to pull together a tip with a cover more densely.
From couple of scraps of a thick board and material 12 mm thick collect the simple adaptation template for milling at an angle 2 ° grooves which will become openings for a verstachny emphasis.
Very often much simply will not have a place for its installation therefore it will be so important to be defined at a preliminary stage, whether your table will begin to move somewhere or not.
Not always there is a sense to do a huge design of a joiner's workbench.
If yes, that use more mobile model and if is not present, then it is possible to use safely its most massive option and firmly to mount in any place. Anyway the final choice will be for you.
Level the right tip of I with a first line of a board C. Mark the centers of 12-millimetric openings (a photo E).
Use an edge of a 12-millimetric drill to transfer the centers of openings in tips of N, I to cover crests.
Use a tip as directing for milling of folds on a cover. Be accurate not to touch with a mill a forward slip of Century.
Short council! Do not stick together a detail of the milling adaptation - a template, and fasten only with their screws. The template again will be required for selection of grooves in the block of a back vice which is wider, than a forward bar of a cover.
7. Put on the left tip of N a crest, having moved up it to a forward slip of Century.
2. Cut a slip In and paste it to a forward bar, having leveled the right end faces of details. Carefully remove the squeezed-out surplus of glue.
Otfrezeruyte at A-G cover end faces from both parties folds 57 wide and 36 mm in depth (a photo of D) to create crests which are inserted into tongues of tips of N, I.